For a window holding an air conditioner, keep its sash and supports undisturbed and use the dedicated window-AC leak response. For a skylight or roof window, use the ceiling/skylight response and its actual product limits; do not borrow the ordinary sash instructions below. Keep clear of wet electrical equipment, damaged glass and loose or unstable window parts. Follow local storm instructions. If a sound window is open, close and lock it through its ordinary controls only when safely reachable; do not force it. Limit a small reachable drip with towels or a container only in a safe area, and promptly contact the building emergency contact or a qualified window/building professional about continuing entry. Do not climb outside, run a hose test or caulk unknown openings. A wet sill alone does not identify the source.
1. Window observationWhere was water first seen, and what access or loose-part concern is already known?
2. Connected wallWho identifies the actual product drain and surrounding wall drainage without assuming they are the same?
3. Separate completionKeep source correction, safe use and wet-material follow-up assigned until resolved.
A window holding an air conditioner has a separate support question
If a window contains an installed AC, do not use the ordinary close-and-lock guidance below to move its sash or change the installation. Keep people clear of apparent movement, loose parts and wet electrical access; do not loosen brackets, alter the tilt or reach outside to investigate. The window may be part of the appliance support.
The window-AC indoor-leak guide adds an installer/appliance/building contact table and a fictional rain-plus-operation example. It distinguishes outdoor collected water from indoor escape without naming the source from timing alone. Ask who assesses the equipment, supported opening and wet materials; a dry sill or stopped unit does not complete those tasks.
Make the area safe before protecting finishes
Move people and pets away from spreading water, broken glass and anything loose around the opening. Follow local warnings during dangerous weather; do not go outside to inspect the wall or stand beneath a damaged ceiling. Leave an immediately dangerous area and call 911. Use the separate ceiling-leak guide if water also appears overhead.
Water beside an outlet, cord or electrical appliance needs urgent electrical safety help. Do not touch wet equipment, unplug a wet cord or enter water to reach a switch or breaker. CDC’s flooded-home guidance warns against using electrical equipment or switching power while standing in water; retain that boundary during a smaller rain leak too.
If the window is open and its ordinary operation is sound and safely reachable, close and lock it as designed. Do not lean out, force swollen or damaged hardware, or operate a loose sash. Andersen describes closed-and-locked conditions for its products’ performance; that does not authorize manipulating a damaged window or prove closing it repairs the leak.
Limit a small drip only when you can stay clear of hazards
A towel or shallow container can catch a small drip reaching a safe, accessible interior surface. Keep the walking route clear and attend to a safely placed container before it overflows. Move a nearby light object only if access is safe. Do not move wet electrical items, climb furniture or reach beneath loose material to place a bucket.
Containment buys no safety clearance for the assembly. If you cannot reach the water without approaching electricity, damaged glass or unstable material, leave it for qualified help. Do not plug in drying equipment until electrical safety and the water’s condition are established. Keep source investigation and affected-material assessment moving even if the rain stops.
Describe the visible location without naming a failed part
From a safe position, note where water was first seen and where it reaches the room. Include the time, rain and wind already observed, and whether the window was open or closed. A photo is optional; do not delay a call or approach a hazard to obtain one. The following is an editorial reporting aid, not a diagnosis.
| What you already see | Useful next report or question |
|---|---|
| Moisture on the room-facing glass | Record the surface, timing and whether it also occurs without rain. Ask for assessment if it recurs or damages finishes; appearance alone does not settle condensation versus entry. |
| Water in a sill or track | Describe the exact location and whether it escapes onto interior finishes. Ask the manufacturer or service provider to identify the actual drainage design. |
| Water at trim, the wall below or the floor | Report active entry and affected materials promptly. Ask who investigates the window-to-wall area as well as the unit. |
| Loose parts, broken glass or water near electricity | Give the safety concern first and keep clear. Request the appropriate urgent building or electrical response. |
| Water or damage above the window or at a ceiling | Report that wider location too. Do not assume the nearest visible joint or the window itself is the source. |
A drainage track is different from an unexplained interior leak
Some window products include drainage paths. Andersen’s care document 9184628 BB, revised June 2, 2023, describes water collecting on the sill of products with drainage systems and leaving through exterior weeps; timing can depend on design. It directs owners to product-specific support when drainage remains a concern.
That example does not establish which part of your window is a drainage track or excuse water entering trim, walls or flooring. Confirm the model and actual instructions with the manufacturer or qualified provider. Do not push tools into a hole, drill a new opening, remove covers or fill a suspected drain with caulk. Owner cleaning is appropriate only when the identified product instructions, permitted task and safe access all match.
Keep general condensation observations in the existing moisture guide. Rain timing, a fogged pane or a wet track is useful context, but none by itself identifies the failed component or clears concealed materials.
Contact help that can investigate the window and surrounding wall
Contact the building emergency or maintenance contact promptly in a shared or managed property. For a homeowner-maintained opening, seek a qualified window service or building professional experienced in water entry; explain whether investigation of the surrounding wall is also needed. Give any electrical or structural concern first so the appropriate service can be involved.
Andersen’s professional water-control article explains that a window and the wall’s water-management layers must work together. The practical question is who can assess that installed connection. The article’s flanged-window details are not instructions to remove your trim, expose a wall or apply sealant around every edge.
Use an existing order, installation or product-label record for model information when available safely. Ask the manufacturer about suitable service and exact instructions. Do not climb outside or dismantle the opening to obtain an identification number. A repair estimate should state what will be investigated, repaired and excluded; use the estimate guide to clarify handoffs.
Arrange wet-material follow-up as well as source repair
EPA advises prompt correction of water problems and drying water-damaged areas and items within 24–48 hours to help prevent mold. That is a reason for timely action, not a waiting period or proof that a concealed wall is dry. Significant damage, suspected contamination or uncertain hidden wet areas need appropriate qualified help.
Ask who will assess affected trim, wall materials and flooring, and what can safely be used while work remains open. Do not paint over a recurring stain or caulk a moldy surface as the solution. A new sealant bead, dry towel or day without rain does not establish completion. Retain actual service findings and any unresolved source or drying work on the free homeowner checklist.
Example: water reaches the trim during a storm
Fictional example: a household notices water on the room-facing trim and floor below a closed window during rain. They keep clear of a nearby outlet, restrict access and contact the building emergency line. From a safe position they report the location, onset and whether the water is continuing; they do not open the window or go outside for a better view.
After the safety response, they ask who will investigate the unit and surrounding wall, who assesses wet materials, and how the proposed repair and later finish work will be recorded. The report remains “water seen at trim during rain; source unconfirmed.” It does not become “failed caulk” merely because a joint is nearby.
Keep a private window-water case note
Call first for active or unsafe entry. Add these details afterward without opening walls or repeating the event. Keep addresses, access instructions and private contact details out of publicly shared photos.
- Room and exact first visible water location: ___.
- Time, weather already observed and whether entry continues: ___.
- Electrical, glass, loose-part or access concerns: ___.
- Window position when first noticed; ordinary safe action already taken: ___.
- Existing model/install record, previous repair and photo reference if available: ___.
- Provider contacted, source investigation, wet-material follow-up and next contact: ___.
Use the entry-door response when the wet opening is a door
An entry door has a different system from the window drainage example above. Water at its indoor threshold does not establish a failed sweep, and a window’s cleaning or drainage procedure should not be transferred to that door. Keep unsafe operation, loose glass, rising water and wet electrical equipment on the urgent response path.
The exterior-entry-door rainwater guide adds a door-specific repair-call table, manufacturer limits on unidentified seal locations and questions about the sill and surrounding opening. Describe the first wet location honestly, obtain a provider whose assessment covers the unresolved area and keep interior drying separate from the source repair.
A basement window with water collecting outside needs a different response
The ordinary close-and-lock guidance above is not an instruction to operate a window holding collected water outside it. Keep clear and request qualified building/drainage help for a filling basement window well, including urgent electrical or structural assistance when needed. Do not open the window, lift a cover or descend to investigate a suspected drain.
The window-well guide adds a focused report table, repair-scope questions and a fictional well-empties-before-assessment example. It keeps actual drainage, window condition and emergency-escape function separate; a new cover is not proof that every question is resolved. Follow flood or evacuation instructions ahead of containment and retain wet-material follow-up.
A skylight or roof window needs its own product and access limits
Use the ceiling-leak guide’s skylight response for water around a roof-mounted unit or its ceiling shaft. Do not apply the ordinary sash close-and-lock or Andersen drainage example above to a skylight or roof window. Keep roof, ladder, wet electrical and unstable-material access with qualified help. Existing records or the provider can establish the actual unit when identifying it would require unsafe access.
A fixed skylight can have a powered interior shade; closing that shade is not a weather closure. Venting and roof-window controls are different questions requiring actual product instructions. Describe glass-side moisture, rain timing and surrounding spread already seen without opening or resetting equipment to find out. Coordinate qualified unit/roof assessment and interior recovery rather than selecting condensation, a failed seal or a caulk repair from appearance alone.
A brick-wall weep is separate from the window product drain
If water is reported at an opening in surrounding brick, do not identify it as a window-track drain from its location alone. In an identified brick-veneer drainage wall, water can leave through an intended wall weep connected to the cavity and flashing. That different assembly does not establish the source of water reaching interior window trim or clear the concealed wall.
The brick-weep guide explains the limited outward-drainage principle and adds opening-identity, connected-trade and completion questions. Ask the qualified window/building provider who assesses both the unit and surrounding wall. Do not apply the window manufacturer’s owner cleaning method to an unknown masonry opening, or seal, probe or spray it to compare water paths. Keep source work and wet-material follow-up open.
When to call a professional
Stop and contact a qualified plumber or other appropriate professional if water is actively spreading, you cannot safely find the shutoff, the leak involves a wall or ceiling, or a repair would require changing plumbing.
Related guides
Sources
- Andersen: Important Product, Care and Maintenance Information, 9184628 BB, June 2, 2023 — product identification, operation and drainage limits
- Andersen: Installing windows for continuous water control — professional explanation of the window-to-wall water-management connection
- CDC: Reentering Your Flooded Home — wet-electrical and storm-damage safety boundaries
- EPA: A Brief Guide to Mold, Moisture and Your Home — prompt source repair, drying and affected-material limits
- JELD-WEN: Care and Maintenance — Interior and Exterior Doors, JCM005 revision July 2024; seal locations, weep gap and hose warning
- Pacific Northwest National Laboratory: Windows and Doors are Fully Flashed — door and wall water-management connection
- National Weather Service: During a Flood — rising water, evacuation and electrical hazards
- EPA: Mold Cleanup in Your Home — fix the water problem, dry materials and obtain experienced contaminated-water help
- GE Appliances: Water Dripping Inside Room — indoor leakage and actual-model instructions
- GE Appliances: Water Dripping Outside — collected water and outdoor function are distinct
- GE Appliances: Spitting or Spraying Water — indoor versus outdoor observations
- GE Appliances: AHE12DX Owner Center — current linked model documentation and support
- GE Appliances: 49-5000622 Rev. 2, January 2023 — AHE08/AHE12 safety, secured installation and water distinctions; specific example (PDF)
- ESFI: Water-Damaged Electrical Equipment — qualified evaluation before restoring power
- CPSC: June 5, 2025 U and U+ window-AC recall — exact-model multi-brand example, not clearance of another unit
- CPSC: current recalls and product-safety warnings
- NWS: After a Flood — hidden hazards and authority-led reentry
- Fairfax County/Northern Virginia SWCD: Flood Proofing Practices — local window, cover and well-drainage distinctions
- Blaine, Minnesota: Emergency Escape and Rescue Opening — local well/drainage and escape context
- VELUX US: FS fixed deck-mounted skylight — product type, separate shade controls and current care gateway
- VELUX: Fixed (Non-Venting) Skylight System care guide V-5192-0226 — fixed-system scope, condensation, shade controls and support
- VELUX USA Help Center: Possible skylight condensation — context, not a diagnosis of active water
- BIA: current Technical Notes index — fired-clay scope and actual Technical Note 7 link
- BIA Technical Note 7: Water Penetration Resistance — Design and Detailing, November 2017; complete 15-page body and figures (PDF)
Free next step
Download the free seasonal maintenance checklist to record observations and follow-up tasks. See the seasonal maintenance routine for more context.
Affiliate disclosure
No affiliate links appear in this guide. If a reviewed recommendation is added, the disclosure will appear beside it.
